How much do you know about tool installation knowledge of 4060 mini engraving machine supplier china? Let's take a look at it briefly below.
1. There are many gaps in the chuck. Before each tool is clamped, the chuck needs to be cleaned with gasoline or WD40 cleaning agent, and the residue in the chuck gap should be checked and removed.
2. The fit between the chuck and the shaft is in contact with the taper hole of the shaft end. If the contact is not good, the tool will not be easy to install, and it is necessary to ensure that the taper surface has good contact. Before loading the knife, you need to scrub the shaft cone with gasoline or WD40 cleaning agent.
3. Put the chuck into the pressure cap, turn the clamp spring slightly, wait until the eccentric part of the pressure cap is recessed into the chuck groove, push the chuck evenly in the direction of the arrow, and then it can be put into the pressure cap.

4. Install the chuck and pressure cap on the spindle of the machine tool. Clean the cylindrical shank of the tool and put it into the holding hole. After confirming that the chuck and the tool are aligned, screw the pressure cap in place by hand. Then use a wrench to tighten the compression cap evenly and firmly until the tool is firmly clamped before use.
5. When loosening the knife, use the wrench to twist the pressure cap in the opposite direction. If you need to change the chuck, loosen the pressure cap to bring out the chuck and the tool, remove the tool, push the chuck forcefully in the direction of the arrow to push it out, and then as needed Just replace it with a chuck with other apertures.
The above is a brief introduction to the tool installation knowledge of 4060 mini engraving machine supplier china.