With the arrival of high temperature in summer, many 50w co2 laser engraving and cutting machines will generate a lot of heat during work, resulting in some failures. Therefore, when using a 50w co2 laser engraving and cutting machine in summer, pay attention to preparing for the cooling of the equipment.

　　In high temperature conditions, people will suffer from heatstroke, and machinery is no exception. To prevent heatstroke and maintain the 50w co2 laser engraving and cutting machine can prolong the service life of the equipment.

　　Water cooling equipment

　　The water cooler is the necessary cooling equipment for the 50w co2 laser engraving and cutting machine. In the high temperature environment, the deterioration of the coolant is very fast. It is recommended to use distilled water and pure water as the coolant. During the use process, it is necessary to regularly clean the scale attached to the laser and the pipeline, so as to avoid the accumulation of scale and the blockage of the coolant, which will affect the cooling and cooling of the laser.

　　Lubrication

　　Each transmission part needs to be wiped and dusted frequently to ensure that the equipment of the 50w co2 laser engraving and cutting machine is clean and tidy, so that the equipment can run more smoothly. Lubricating oil needs to be filled between the guide rail and the gear, and the filling time interval should be adjusted. Compared with the spring and autumn seasons To shorten about double, and often observe the oil quality.

　　50w co2 laser engraving and cutting machine line inspection

　　Check and replace worn wires, plugs, hoses and connectors. Check whether the connector pins of electrical components are loose, and tighten them in time to avoid electrical burnout and unstable signal transmission caused by poor contact.